|
3111 PHOTOMETER CPU ERROR (aa, b)
System Status
(1). Although the DPR can continue functioning, the ANL is inoperable.
(2). The mode changes to Stop.
Cause
(1). Any of the following errors occurs in the photometry sub-CPU.
a). Sub-CPU fails to become ready to write a command reception.
b).The CPU receives an undefined command.
c). Parameter error.
User Action
Reinitialize the system. If the error recurs, call Olympus Technical Support.
Additional Information
(1). Reset the system. If an error recurs in resetting, check the sub-CPU using ANL DIAG. If an error still recurs, take the same measures as taken for an error in initialization.
Error details
aa : Send command (Hex.)
b : System status
1 : System busy
2 : Wheel rotation disable
3 : Parameter error
4 : Unknown command
5 : Double receive command
6 : Initial position error after INITIALIZE
7 : Stop position error after photometry
3203 CUVETTE WHEEL ROTATION ERROR T (aa,bb,cc)
System Status
(1). The mode changes to STOP.
Cause
(1). An error occurred while the cuvette wheel is rotating.
User Action
Contact Olympus Technical Support.
Additional Information
(1). An error occurs when the cuvette wheel is rotating.
Error codes (Decimal)
T : Time sequence No.
aa : 1 : Motor busy
2 : The cuvette cleaning motor is busy when operation starts
3 : The S/R1 mixer-bar unit motor is busy when operation starts
4 : The sample probe cuvette position sensor(S34) turn on and the sample agitation unit up / down motor is busy when operation starts
5 : The R1 reagent probe cuvette position sensor(S43) turn on and the reagent agitation unit up / down motor is busy when operation starts
6 : The cuvette cleaning upper sensor(S61) turn off when operation starts
7 : The S/R1 mixer bar unit upper sensor(S60) turn off when operation starts
8 : The sample probe cuvette position sensor turns on and the upper position sensor turns off when operation starts
9 : The R1 reagent probe cuvette position sensor(S43) turns on and the upper position sensor(S46) turns off when operation starts
10 : The cuvette wheel fails to rotate
11 : The cuvette wheel stop position sensor(S57) turns off on completion of operation
12 : The cuvette wheel origin sensor(S56) turns off after moving to the origin
13 : The cuvette wheel origin sensor(S56) turns on after getting out of the origin
14 : The cuvette wheel stop position sensor(S57) turns on after getting out of the origin
15 : The R2 mixer-bar unit motor is busy when operation starts
16 : The sample probe cuvette/origin position sensor(S34,S33) turn on and the sample agitation unit up / down motor is busy when operation starts
17 : The R2 reagent probe cuvette position sensor(S115) turn on and the reagent agitation unit up / down motor is busy when operation starts
18 : The R2 mixer bar unit upper sensor(S132) turn off when operation starts
19 : The sample probe cuvette origin position sensor(S33) turns on and the upper position sensor turns off when operation starts
20 : The R2 reagent probe cuvette position sensor(S115) turns on and the upper position sensor(S118) turns off when operation starts
bb : Time table No.
cc : Phase No. | 
